Programming of parameters
Password input system

Programming in operation (changing the configuration of corrector) using a keyboard or service program should be performed by the representative of the gas company after setting the switch mode to "ON" position and entering a password of 5 digits. During repair, the programming can be performed by a representative of the service center.

The operating mode switch is located on the electronic board inside the housing of the unit. Access to it is possible after opening the seals on the lid of the calculator and the seals on the lid closing the electronic board.

When switching the key to the "1" position, the corrector configuration can not be changed, only data viewing and reading of the archives are possible.

Name of the parameters that could be changed

Switch positions

Contract hour

"ON" or "1" using only the password

Setting the real time and date

Density of gas under normal conditions

Carbon dioxide and nitrogen contentsа

Atmosphere pressure

Company name

Free access

Display time

ATTENTION! The device is supplied with a switch mode set to "ON" position and without set password.

All data entered during programming must be necessarily agreed between consumer and supplier..

If the password is lost, the gas supplier should contact with manufacturer and request the password and indicate the device number.

The manufacturer's password can only be used once on a single device with a specific number.